Datasheet

page 10
1 2 3
Before you plug the mikromedia
™
board into the
socket, make sure that the power supply is turned
o. Images below show how to correctly plug the
board. First make sure that mikromedia
™
board
orientation matches the silkscreen outline on the
mikromedia
™
workStation v7 board socket. Place the
mikromedia
™
board over the socket so that each male
header is properly aligned with the female socket,
as shown in Figure 4-4. Then put the mikromedia
™
board slowly down until all the pins match the
socket (make sure you don't push the screen). Check
again if everything is placed correctly and press the
mikromedia
™
board until it is completely plugged
into the socket as shown in Figure 4-5. Now you
can turn the power supply on.
How to properly place your mikromedia
™
board into the socket?
Figure 4-3: On-board
mikromedia
™
socket has
silkscreen markings which
will help you to correctly
orient the mikromedia
™
board before inserting.
Figure 4-4:
Place the
mikromedia
™
board in the
socket so
that pins
are aligned
properly.
Figure 4-5: Properly
placed mikromedia
™
board.
mikromedia