Datasheet

Page 18
Page 19
Figure 3-11:
Placing ICD2®
connector
The microcontroller can be also programmed with ICD2®
or ICD3® programmer. These programmers connects
with mikromedia board via ICD2 CONNECTOR BOARD.
Programming with
ICD2
®
or ICD3
®
programmer
In order to enable the ICD2® and ICD3® programmers to be connected to the
mikromedia board, it is necessary to provide the appropriate connector such as the
ICD2 CONNECTOR BOARD. This connector should be rst soldered on the CN5 connector.
Then you should plug the ICD2® or ICD3® programmer into it, Figure 3-11.
Figure 3-12:
Connecting ICD2®
or ICD3® programmer