Datasheet

EasyTF T
page 4
1 2 3
Before you plug the EasyTFT board into the GLCD
socket, make sure that the power supply is turned
o. The gures below show how to plug the EasyTFT
board properly. First make sure that EasyTFT board
orientation matches the plastic distancer and male
headers on the Easy development board GLCD socket.
Place the EasyTFT board over the socket so each male
header is properly aligned with the female headers
as shown in Figure 1-1. Then put the EasyTFT board
slowly down until all the pins match the socket as
shown in Figure 1-2. Check again if everything is
placed correctly and press the EasyTFT board until
it is completely plugged into the socket as shown in
Figure 1-3. If done correctly all the pins should be
fully inserted. Now you can turn on the power supply.
How to properly place your EasyTFT board into the socket?
Figure 1-1: On-board GLCD socket has plastic
distancer and male headers which will help you to
correctly orient the MCU card before inserting.
Figure 1-2: Place the EasyTFT
board on the socket so that pins
are aligned correctly.
Figure 1-3: Properly placed MCU
card in Easy development board GLCD
socket.