User manual

Page 21
The microcontroller can be also programmed with ST-LINK V2 programmer and
mikroProg Suite™ for ARM® software, Figure 3-11 . This programmer connects
with mikromedia board via mikroProg to ST-LINK V2 adapter.
Programming with ST-LINK V2 programmer
In order to adjust the ST-LINK™ V2 programmer
to be connected to the development system, it
is necessary to provide the appropriate adapter
such as the mikroProg to ST-LINK V2 adapter.
2x5 male headers should be rst soldered on the
CN5 connector pads. Then you should plug adapter into
the ST-LINK V2 programmer (2x10 male header), and plug
IDC10 at cable in male headers, Figure 3-13
Figure 3-13:
Connecting ST-LINK™ V2
programmer
Figure 3-12:
mikroProg™ to
ST-LINK™ V2 adaper
Page 20