User manual

Page 18
Page 19
The microcontroller can be programmed with external mikroProg™ for STM32® programmer and mikroProg Suite™ for ARM® software.
The mikroProg™ programmer is connected to the development system via the CN5 (JTAG) connector. You can choose between two ways to
program microcontrollers , Figure 3-14:
Programming with mikroProg
™
programmer
mikroProg™
is a fast USB 2.0
programmer with mikroICD™
hardware In-Circuit Debugger.
It supports over 180 ARM® Cortex™
M3 and Cortex™ M4 microcontrollers from
STM32® family. Outstanding performance, easy
operation and elegant design are it’s key features.
Figure 3-10:
Connecting
mikroProg™ to
mikromedia™
01
02
Via JTAG interface
Via Serial wire debug (SWD) interface
Before attaching the programming connector, you have to solder the provided 2x5 male header to the JTAG pads (CN5)
A
v
a
i
l
a
b
l
e
o
n
P
r
o
d
u
c
t
D
V
D
!
NOTE: