Datasheet

Page 18
Page 19
mikroProg Suite
™
for ARM
®
Software
A
v
a
i
l
a
b
l
e
o
n
P
r
o
d
u
c
t
D
V
D
!
On-board mikroProg™ programmer requires special programming software called mikroProg
Suite™ for ARM®. This software is used for programming of all supported microcontroller
families with ARM® Cortex™-M3 and Cortex™-M4 cores. Software has intuitive
interface and SingleClick™ programming technology. To begin, rst locate the
installation archive on the Product DVD:
Click the Detect MCU button in order to recognize the device ID.
Click the Read button to read the entire microcontroller memory. You can click the Save
button to save it to target HEX le.
If you want to write the HEX le to the microcontroller, rst make sure to load the target
HEX le. You can drag-n-drop the le onto the software window, or use the Load button to
open Browse dialog and point to the HEX le location. Then click the Write button to begin
programming.
After downloading, extract the package and double click the executable
setup le, to start installation.
DVD://download/eng/software/development-tools/arm/mikroprog/
mikroprog_suite_for_arm_v110.zip
Copyright ©2011 Mikroelektronika.
All rights reserved. Mikroelektronika, Mikroelektronika logo and other
Mikroelektronika trademarks are the property of Mikroelektronika.
All other tradmarks are the property of their respective owners.
Unauthorised copying, hiring, renting, public performance and
broadcasting of this DVD prohibited.
20122011
www.mikroe.com
02
01
03
Quick Guide
Figure 3-11:
mikroProg Suite
™
for ARM®
window