Datasheet

Page 14
6. mikroProg
™
to 20-pin JTAG connector
In order to connect mikroProg to 20-pin male JTAG connector it is necessary
to use appropriate adapter, such as the mikroProg
™
to ST-LINK V2 adaper,
Figure 6-1. This adapter should be rst placed on 2x10 male connector.
Then you should plug in the mikroProg
™
into 2x5 male header, Figure 6-2.
Figure 6-2:
Connecting
mikroProg™
programmer
Figure 6-1:
mikroProg™
to ST-LINK V2
adaper