Datasheet

page 10

1 2 3

EasyMx PRO

Before you plug the microcontroller card into the

socket, make sure that the power supply is turned

o. Images below show how to correctly plug the

card. First make sure that MCU card orientation

matches the silkscreen outline on the EasyMx

PRO

™

v7 STM32 board MCU socket. Place the

MCU card over the socket, so each male header is

properly aligned with the female socket, as shown

in Figure 4-4. Then put the MCU card slowly down

until all the pins match the socket. Check again if

everything is placed correctly and press the MCU

card until it is completely plugged into the socket

as shown in Figure 4-5. If done correctly, all pins

should be fully inserted. Only now you can turn on

the power supply.

How to properly place your MCU card into the socket?

supported MCUs

Figure 4-3: On-board MCU

socket has silkscreen

markings which will help

you to correctly orient the

MCU card before inserting.

Figure 4-4:

Place the

MCU card on

the socket

so that pins

are aligned

correctly.

Figure 4-5 Properly

placed MCU card.