User Manual

8. Support
MikroElektronika off ers Free Tech Support
(www.mikroe.com/esupport) until the
end of product lifetime, so if something goes
wrong, we are ready and willing to help!
7. Code Examples
.com
Once you have done all the necessary
preparations, it’s time to get your click
board up and running. We have provided
the examples for mikroC, mikroBasic and
mikroPascal compilers on our Libstock
website. Just download them and you are
ready to start.
.com
5. Adapter Click™ Board Schematic
MIKROBUS DEVICE CONN.
AN
RST
CS
SCK
MOSI
MISO
+3.3V
GND
PWM
INT
RX
TX
SCL
SDA
+5V
GND
VCC3.3
1 2
3 4
5 6
7 8
9 10
CN2
SCK/SCL
MISO/SDA MOSI
CS
RC1RC0
VCC
TX RX
MISO/SDA
SCK/SCL
VCC
VCC5
TX
RX
MOSI
MISO
SCK
SCL
SDA
MISO
SDA
SCK
SCL
RC1
RC0
CS
J2
J3
J1
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.
Specifi cation and information contained in the present schematic are subject to change at any time without notice. Copyright © 2013 MikroElektronika. All rights reserved.
6. Jumpers
There are two jumpers for SPI/I
2
C selection
and one used to select whether 3.3V or 5V
power supply will be used.