User manual

!
10
ClickBoards
To send or receive information to or from the physical click boards
there are equivalent claw components.
All you need to do is connect the claw components to the Claw
outputs on the FlowPaw component.
Just make sure that the component you connect to a claw output
matches the click board plugged into the corresponding claw on
the physical board.
Proximityclickboardon
Claw1isaccessedby
theequivalentcomponent
attachedtotheClaw1
outputontheFlowPaw
component.
Clawcomponentsmodel
eachsupportedclickboard