User`s guide

page 10
1 2 3
EasyMx PRO
v7
Before you plug the microcontroller card into
the socket, make sure that the power supply is
turned o. Images below show how to correctly
plug the card. First make sure that MCU card
orientation matches the silkscreen outline on the
EasyMx PRO
™
v7 board MCU socket. Place the MCU
card over the socket, so each male header encloses
the right angle with the female socket, as shown
in Figure 4-4. Then put the MCU card slowly down
until all the pins match the socket. Check again if
everything is placed correctly and press the MCU
card until it is completely plugged into the socket
as shown in Figure 4-5. If done correctly, all pins
should be fully inserted. Only now you can turn on
the power supply.
How to properly place your MCU card into the socket?
supported MCUs
Figure 4-3: On-board
MCU socket has silksreen
markings which will help
you to correctly orient the
MCU card before inserting.
Figure 4-4:
Place the
MCU card on
the socket
so the pins
are aligned
correctly.
Figure 4-5 Properly
placed MCU card will have
equally leveled pins.