User manual

81
Web Browser (different Network number)
· Change the computer’s IP address to communicate with the printer
o Connect the printer directly to the Host using an Ethernet crossover cable.
o Check Control Panel>Network Connections>Local Area Connections>Properties
o Scroll down and highlight Internet Protocol (TCP/IP)
o Click properties.
o Record the present settings on this screen before making any changes.
o Click 'Use the following IP address'. Fill in the fields as follows:
o IP address: 10.0.0.191
o Subnet mask: 255:255:255:0
o Default gateway 10.0.0.191
o You can leave the DNS fields blank.
o Click OK, then Close.
o Wait 30 seconds.
You should now be able to ping the printer at 10.0.0.192.
· Change the printer’s IP address to communicate on your network
o Set browser to 10.0.0.192
o Change the ETHERNET setting on the printer from DHCP ENABLED to YES
o Enter the desired IP ADDRESS.
o Do not change the printer’s subnet mask or default gateway
o (A WAN using multiple gateways may require the setting of the default gateway and subnet
mask.)
o Save
· Set the Computer back to its original settings (IP address, subnet mask, default
gateway)
o Remove the Ethernet crossover cable
o Connect the computer and the printer to the network using standard Ethernet cables
o Restore the computer’s original network settings in Control panel>Network
Connections>Local Area Connections>Properties
NOTE: The printer's IP address is printed on the test ticket. If using DHCP, it may take up to one minute to
obtain a valid IP address. Until then, it will display all zeros on the test ticket.