User manual

78
CHANGING ETHERNET PARAMETERS SUPPLEMENT
CONTROL PANEL CONFIGURATION:
CHANGING 'ETHERNET' SETTING
1. Please follow these steps to change the ETHERNET setting on your Ethernet printer.
2. Depress both the MENU and CHOICES buttons while turning on the printer. Keep both buttons
depressed until FACTORY MENU appears in the LCD window or the display starts scrolling through
different topics.
3. Using the MENU button scroll down to the ETHERNET? topic and press the CHOICE button.
4. The blinking cursor indicates the current setting selected. Every time you press the CHOICE button the
setting option will change.
5. Choose the appropriate setting. Select ‘DHCP ENABLED’ for dynamic addressing or ‘YES’ for using a
fixed IP address.
6. Press the TEST button to enter that setting.
7. Now the display will show EXIT AND SAVE. Press the TEST button to save the setting entered.
8. Note: if you selected ‘YES’ then you can use the default IP of 10.0.0.192 or set a different one as
described next.
CHANGING 'IP ADDRESS'
1. Please follow these steps to change the fixed IP address on your Ethernet printer. Note: if using a fixed
IP address make sure the ‘ETHERNET’ setting is set to ‘YES’ (see above).
2. Depress both the MENU and CHOICES buttons while turning on the printer. Keep both buttons
depressed until FACTORY MENU appears in the LCD window or the display starts scrolling through
different topics.
3. Using the MENU button scroll down to the IP ADDRESS? topic and press the CHOICE button.
4. The blinking cursor indicates the current IP numeric value selected. Every time you press the CHOICE
button the numeric value will change.
5. Using the TEST button will move you over to the next numeric value.
6. Continue steps 4 & 5 to program the desired IP address value.
7. At the end the display will show EXIT AND SAVE. Press the TEST button to save the IP address you
just entered.