User manual

2- sound buzzer every 15s.

3- sound buzzer every 30s.

4- sound buzzer every 45s.

SHUFFLE MODE ENABLED/DISABLED COMMAND -

This feature is normally disabled with the exception of ATM style printers which have it enabled as the

factory default setting

When enabled, shuffle mode causes the printer to move the ticket stock forward in

small increments once every 15 minutes until the ticket reaches a predetermined limit. Once the limit has been

reached, the ticket is returned to its normal idle (top of form) position and the whole process is repeated.

Because of this behavior an operator may see the ticket stock protruding from the printer if the printer has

remained idle for an extended period of time. However, this is normal and will not effect positioning of text on a

printed ticket; a ticket is always returned to its top of form position prior to printing.

CUTTER TYPE COMMAND - <mct#>

Note: This function is set at the factory and generally should not be changed.

This command sets the cutter type for a Mini printer.

1 – Silent

2 – Boca

CUTTER SPEED COMMAND - <mcs#>

Note: This function is set at the factory and generally should not be changed.

This command sets the cutter speed for a Boca cutter.

1 – Normal

2 – Slow

ORIENTATION NORMAL/REVERSE COMMAND - <rte>/<rtd>

Defines the orientation of the ticket portrait mode layout. The normal default mode is disabled <rtd>. Reverse

<rte> will rotate the ticket portrait mode layout 180°. This will only work in conjunction with the boca print driver.

It is intended to make the Boca print driver compatible with the HP Laserjet IIP print driver. Please consult the

PRINTER DRIVER SUPPLEMENT for additional information.

MAGNETICS COMMANDS………….

MAGNETICS MODE ENABLED/DISABLED COMMANDS - <mme>/<mmd>

These commands set the printer in magnetics mode <mme> or non-magnetics mode <mmd> after initializing.

Note: the following commands are valid for magnetic printers only.

MAGNETICS TICKET LENGTH COMMAND - <mtl#>

Note: This function should only be used by an experienced user.

This command sets the magnetic ticket length. The values can range as shown below:

1 – 3.375”

2 – 4.0”

MAGNETICS PRINTER STYLE COMMAND - <mps#>

Note: This function should only be used by an experienced user.

This command sets the magnetics printer style. The values can range as shown below:

1 – Normal

2 – Long

3 – Switches

ADJUST REVERSE COUNT COMMAND - <mrc#>

Note: This function should only be used by an experienced user.