Manualshelf

User manual

ManualsBrandsMikMek ManualsComputer equipmentSubMicro
51525354555657585960
55
INC REV COUNT?
Enables the operator to move the position to the right (towards the ticket exit
area). Print position value is in increments of .003” for 300dpi and .005” for 200dpi. Depressing
CHOICES changes this value. This adjustment has a limited range and is set at the factory.
DEC REV COUNT?
Enables the operator to move the position to the left (towards the ticket
entrance area). Print position value is in increments of .003” for 300dpi and .005” for 200dpi.
Depressing CHOICES changes this value. This adjustment has a limited range and is set at the
factory.
INC BURST COUNT?
Enables the operator to move the burst position to the left (towards the
ticket entrance area). Cut counts are increments of .003” for 300dpi and .005” for 200dpi. Depressing
CHOICES changes the count value. The burst count value can be set within +/-75 of the ticket length.
This is set at the factory.
DEC BURST COUNT?
Enables the operator to move the cut or tear position to the right (towards
the ticket exit area). Cut counts are decrements of .003” for 300dpi and .005” for 200dpi. Depressing
CHOICES changes the count value. The burst count value can be set within +/-75 of the ticket length.
This is set at the factory.
AUTO REPRINT?
Enables or disables the auto reprint feature. Your choices are YES (Enabled) or
NO (Disabled). YES is factory default.
PURGE ON VOID?
Enables or disables purge on void feature. Your choices are YES (Enabled) or
NO (Disabled)
MAGNETICS TYPE?
Defines the type of magnetic printer. This feature is set at the factory and
should not be changed. Here are the following choices:
TRACK SELECTION?
Defines the track selection for the printer.
Here are the following choices:
TRACK 2 DENSITY?
Defines track 2 density. Your choices are 75bpi (factory default) or 210bpi.
Experienced users should only use this function.
TRACK ENCODING?
Defines track encoding. Your choices are 7/5/5 (factory default) or 7/7/7.
Experienced users should only use this function.
BOTTOM
TOP
CENTER
MINI KIOSK
TRACKS 1/2/3
TRACKS 1/2
TRACK 1
TRACK 2
DISABLED