User manual

54
CUTTER TYPE? Defines the type of cutter the printer has.
SILENT – This is the old Silent Cutter assembly.
BOCA - improved, stepper motor driven cutter assembly.
This feature is set at the factory and should not be changed.
CUT SPEED? Defines the cut speed for a BOCA cutter type.
This feature is set at the factory and should not be changed.
ORIENTATION? Defines the orientation of the ticket layout.
REVERSE will rotate ticket layout 180°. (This will only work in conjunction with the boca200 or boca300 print driver)
NORMAL (Default).
Please consult the PRINTER DRIVER SUPPLEMENT for additional information.
MAGNETICS? Defines if a printer is set up for magnetics. Your choices are YES (Enabled) or NO
(Disabled). This feature is only set to YES for a MAG model printer.
ETHERNET? Only used for printer with Ethernet interface connector.
Your choices are YES (Enabled), NO (Disabled), DIAGNOSTICS , VALID PACKETS and DHCP
ENABLED (Dynamic addressing). Please consult the ETHERNET INTERFACE ADDENDUM for
additional information.
IP ADDRESS? Enables the operator to change the printer’s Ethernet IP Address. Please consult
the ETHERNET INTERFACE ADDENDUM for additional information.
SUBNET MASK? Enables the operator to change the printer’s Ethernet Subnet Mask value. Please
consult the ETHERNET INTERFACE ADDENDUM for additional information.
DEFAULT GATEWAY? Enables the operator to change the printer’s Ethernet default Gateway
value. Please consult the ETHERNET INTERFACE ADDENDUM for additional information.
SPEED/DUPLEX? Enables the operator to change the printer’s Ethernet speed and duplex setting.
Please consult the ETHERNET INTERFACE ADDENDUM for additional information.
RFID? Only used for printer with RFID interface connector.
Your choices are NO (Disabled), MIFARE ULTRALITE and I-CODE (SL2). Please consult the RFID
INTERFACE ADDENDUM for additional information.
USB DEVICE TYPE? Only used for printer with USB interface connector. This function enables the
operator to change the printer’s USB device class from 7 (Printer) to 3 (HID). The USB printer will
then need to be reinstalled whenever this setting is changed. This new setting is implemented in the
FGL 26/46 models only.
EXIT AND SAVE ! Will save any changes made to the above menu options.
If you wish to save the new value then press TEST, if not press MENU.
JUST EXIT? This function will exit the menu options without saving any changes. If you want to exit
without saving the new values then press TEST. If not the depress MENU to continue going through
the menu topics.
Note: The following commands are valid for magnetic printers only.
TICKET LENGTH COMMAND? Defines the magnetic ticket length. Your choices are 3.375”
(factory default) or 4.0”. Experienced users should only use this function.
PRINTER STYLE? This feature is set at the factory and should not be changed.