User manual

53
RIBBON - The printer will feed out one blank ticket. This mode is used for label stock to prevent
peeling.
PRINT INTENSITY? Controls the darkness of ticket print out.
Here are the following choices:
SKI MODE? Enables the operator to set an unprintable area on the first .50” of a ticket. This is
ideally used for label stock. Your choices are YES (Enabled) or NO (Disabled).
FLASH ACK MODE? Enables or disables an ACK being sent back to the host after a file flash or
RAM operation. Your choices are YES (Enabled) or NO (Disabled). NO is factory default.
SOFTWARE BUSY? Defines if the printer will go busy after each byte is received. Your choices are
YES (Enabled) or NO (Disabled). This feature should normally be disabled.
BI-DIRECTIONAL? Enables or disables the Bi-Directional parallel interface protocol. Your
choices are YES (Enabled) or NO (Disabled). This feature should normally be disabled.
TEST TICKET? Defines they type of self test ticket printed.
STANDARD
Normal self test ticket pattern
(factory default)
CONFIGURATION 1
To print configuration settings if printing on a 1” wide ticket
CONFIGURATION 2
To print configuration settings if printing on a 2” wide ticket
CONFIGURATION 3
To print configuration settings if printing on a 3” wide ticket
CONFIGURATION 4
To print configuration settings if printing on a 4” wide ticket
BASEBALL MODE? Defines the type of software emulation protocol for certain Baseball teams in
the US. This feature is set at the factory and should not be changed.
USB? Only used for printer with USB interface connector.
Your choices are YES (Enabled) or NO (Disabled)
FONT ENCODING? This feature is set at the factory and should not be changed.
ACKNOWLEDGE? Defines the ends of print acknowledgment sent out by the printer.
Your choices are NORMAL or DELAYED. Experienced users should only use this function.
HIGH SPEED MODE? Only used on printers with a special pulley ratio to allow high speed
printing. This feature is set at the factory and should not be changed.
BUZZER? Only used for printer with a buzzer.
Your choices are DISABLE (Disabled). 15 SECONDS, 30 SECONDS or 60 SECONDS (Interval
between buzzes).
SHUFFLE MODE? Shuffles the ticket every 15 minutes when the printer is inactive (please refer to
the shuffle mode commands <sfe><sfd> for a full description). Your choices are YES (Enabled) or NO
(Disabled). This feature is normally disabled with the exception of ATM style printers which
have it enabled as the factory default setting.
LIGHT
MED LIGHT
NORMAL
(factory
default)
MED DARK
SHORT HEAD LIFE