User manual

50
FGL CONTROL PANEL
The 24/44 and 26/46 printers allow the user to adjust various printer options through the control panel.
To access and use the OPERATOR MENU, follow these steps:
1. Ticket stock should be loaded into the printer. The LCD window displays FGL46G# - A# (# - number value
depends on revision level; B represents the software series level; A# is the font)
2. Press both MENU and TEST switches simultaneously for about 3 seconds. The LCD window displays
OPERATOR MENU. (To access the FACTORY MENU, press MENU and CHOICES instead of MENU and
TEST.) WARNING: Improper use of the factory menu may disable your printer.
3. To scroll through the menu topic, use MENU stopping on the topic you wish to change.
4. Press CHOICES to scroll through choices in the selected topic. NOTE: The printer displays a blinking
cursor for the values presently stored in the printer.
5. Once you have found the new value you want, press TEST. The LCD window displays EXIT AND SAVE?.
If you wish to save the new value then press TEST again.
6. If you do not wish to save the new value then press MENU. The LCD window displays JUST EXIT?.
Press TEST to exit the OPERATOR MENU without saving new values or press MENU to enter back
into the OPERATOR MENU.
The below chart lists the present menu topics. These topics are subject to change.
OPERATOR MENU
FACTORY MENU
FACTO
RY MENU (Continued)
BAUD RATE? BAUD RATE? FLASH ACK MODE?
MINI/MICRO? MINI/MICRO? SOFTWARE BUSY?
PRINT SPEED? PRINT SPEED? BI-DIRECTIONAL?
DIAGNOSTIC MODE? DIAGNOSTIC MODE? TEST TICKET?
TICKET TYPE? TICKET TYPE? BASEBALL MODE?
STATUS ENABLED? STATUS ENABLED? USB?
TRANSPARENT MODE? TRANSPARENT MODE? FONT ENCODING?
PAPER MODE? PAPER MODE? ACKNOWLEDGE?
INC CUT1 COUNT? HEAD DPI? HIGH SPEED MODE?
DEC CUT1 COUNT? SPECIAL HEAD? BUZZER?
INC CUT2 COUNT? PATH TYPE? SHUFFLE MODE?
DEC CUT1 COUNT? BUFFER MODE? CUTTER TYPE?
PRINT MODE? CLEAR DOWNLOAD? CUTTER SPEED?
PRINT INTENSITY?
DEFAULT SETTINGS?
ORIENTATION?
TEST TICKET? INC CUT1 COUNT? MAGNETICS?
EXIT AND SAVE? DEC CUT1 COUNT? ETHERNET?
JUST EXIT INC CUT2 COUNT? IP ADDRESS?
DEC CUT2 COUNT? SUBNET MASK?
2
-
SIDED PRINTER?
DEFAULT GATEWAY?
PARK TICKET? SPEED/DUPLEX?
TICKET MODE? RFID?
PRINT MODE? USB DEVICE TYPE?
PRINT INTENSITY? EXIT AND SAVE?
SKI MODE? JUST EXIT
Selects proper menu topic
(baud rate, cut count, etc.)
Scrolls through choices in
individual menu topics
Enters new value. Also
saves new values