User manual

PRINT / NO CUT (HOLD TICKET IMAGE) - <r>

This command works just like the hold command above except that in cut mode no ticket is cut until a normal

print command (<p> or FF) is sent.(NOTE: This command is not currently supported when using soft fonts. This

command is not applicable to MagMini and Dual printers.)

SPECIAL COMMANDS

The following commands are to be transmitted independently (without the < or > characters).

NORMAL PRINT / CUT COMMAND - 0CH (FF)

This command prints and cuts the ticket.

PRINT / NO CUT - 1DH

This command causes the printer to print a ticket without cutting.

CASH DRAW COMMAND - 1CH

Obsolete

LOAD DOWNLOADABLE LOGO - ESC<RC0,0><G#>(BYTE1 - BYTE#)<RC#,#><G#>(BYTES)...ESC

This command allows the user to store up to 128K bytes of logos in the Ghostwriter's memory. Once stored, the

logos can be accessed via a simple command. This will be discussed in detail in the LOGO SUPPLEMENT

SECTION.

CLEAR DOWNLOADABLE STORAGE AREA - ESC c

Note: this is a character 27 followed by small c (character 99).

The printer has a separate memory area that it reserves for downloaded logos and fonts. Normally, all

information sent is stored sequentially in memory starting at the beginning. When the memory is full or if you

want to change the information in memory, you must clear out the old information before sending the new

information. You can do this by turning off the printer or sending this command. Note: if the printer has flash

memory, the information is not lost after power off so you must send this command if you want to reuse the

download space. This command clears the download logo and font pointers so that new information can be

downloaded to the printer at the beginning of memory.