User manual

116
This command permanently stores the retry value (#) in flash. The value (#) can range from 1-5. The default
value is 2. This is the number of times the printer will retry performing the requested RFID operation before
printing a ‘Void’ ticket.
RFID TIMEOUT COMMAND - <rfto#>
This command permanently stores the timeout value (#) in flash. The value (#) can range from 1-256ms. The
default value is 60ms. This is the period of time that the printer will wait for a response from the RFID encoder
before timing out. This will vary among different stocks and RFID technologies. You should increase the timeout
amount if ‘timeout error’ void tickets are being printed.