Operator`s manual

15
8.2.2 Logic Board (Installation)
1. Align Main Logic Board so that the four mounting holes are above the four
fasteners.
2. Press logic board straight down onto the fasteners.
3. Attach connectors going to the main logic board.
4. Secure the heat sink to the cabinet.
8.3 General Cleaning
The interior of the printer should be cleaned whenever there is a visible accumulation of dust. Use a
small vacuum for cleaning. Be careful not to jar any of the printer’s parts loose.
9.0 Spare Parts List
Refer to the BOCA Systems website at www.bocasystems.com, TECH SUPPORT section for the
most current Spare Parts List.
PART #
DESCRIPTION
P19-1000 AC CORD
P31
-
1000
AC FILTER
P31-1001 AC FILTER/POWER SWITCH
P49
-
1010
ADJUSTABLE PAPER GUIDE SLIDER (complete)
P62-1000 ANTI STATIC BRUSH ONLY (2”)
P62
-
1001
ANTI STATIC BRUSH ONLY (3.25”)
P62-1002 ANTI STATIC BRUSH WITH MTG. BRACKET (2”)
P62
-
1003
ANTI STATIC BRUSH WITH MTG. BRACKET (3.25”)
Printer dependent CABINET, MICRO PLUS
423226-20 CABLE RIBBON, CONTROL PANEL 20” (FLG 22 & 42)
423123
CABLE RIBBON, DATA CABLE PARALLEL (for FGL 22 & 42)
423124 CABLE RIBBON, DATA CABLE SERIAL (for FGL 22 & 42)
422557
-
16
CABLE RIBBON, THERMAL HEAD (3.25” & 4.0”) 16”
422557-18 CABLE RIBBON, THERMAL HEAD (3.25” & 4.0”) 18”
422558
-
16
CABLE RIBBON, THERMAL HEAD (BS2002 & BS3002) 16”
422558-25 CABLE RIBBON, THERMAL HEAD (BS2002 & BS3002) 25”
432020
CAM LEVER, PAPER GUIDE
421671-1 CONTROL PANEL, FGL 22 & 42
422560-5 CONTROL PANEL DECAL, FGL 22 & 44
COVER MTG. HARDWARE (SCREW, FL,LW)
420880 MI COVER, MICRO CABINET
420880 MIP
COVER, MICRO PLUS CABINET
P19-1004 DC HARNESS, MICRO (FGL 20 & 40)
421682
-
**
DEFLECTOR, PAPER GUIDE (** Printer Dependent )
P50-1011 DRIVE BELT, 100T
P50
-
1003
DRIVE BELT, 102T
P50-1012 DRIVE BELT, 105T
P50
-
1008
DRIVE BELT, 110T
P50-1002 DRIVE BELT, 89T
P51-1007 DRIVE PULLEY, 20T (Large ID .25”)
P51
-
101
4
DRIVE PULLEY, 20T (small ID 5mm) Used on printers with LCD displays
P51-1010 DRIVE PULLEY, 22T (Large ID )
P51
-
1015
DRIVE PULLEY, 22T (small ID 5mm) Used on printers with LCD displays
P51-1011 DRIVE PULLEY, 30T