Operator`s manual

6
4.0 Installation
The BOCA MINI series printer was designed to be mounted either on a desktop or shelf (horizontal
model) or vertically in a counter top (see Appendix B for installation of vertical printers).
Prior to site preparation and installation, the printer should be powered up and run in the self-test
mode.
• Lay the printer flat on a counter top with the cover open.
• Attach the AC cord and interface cable into the proper connectors.
• Install Ticket Hopper to catch the tickets.
• Turn power on and you will hear the cutter motor cycle. The LCD will display PAPER OUT.
• Begin loading tickets through the entrance slot with a smooth motion until the printer
automatically positions the ticket.
NOTE: Tickets should be loaded with the black mark facing down. Refer to the BOCA systems
website at www.bocasystems.com, THERMAL TICKETS section for ticket specifications.
• After the ticket is automatically positioned (the READY LED will be illuminated), press the
TEST button located on the control panel to print a test ticket.
• Verify that the printer properly works with your system by issuing a ticket through your
computer system.
You may now install the printer in its permanent location. Adequate room should be provided behind
the printer for the smooth feeding of ticket stock. Please do not prevent the ticket hopper (horizontal
models) from operating by touching tickets during the printing cycle.
5.0 Configuration
The BOCA MINI series printer is factory configured for a variety of customer requirements.
For a comparison of the different electronics packages, refer to the BOCA Systems website at
www.bocasystems.com, THE BASICS section.
For a listing of configuration choices, refer to the BOCA Systems website at www.bocasystems.com,
SPECIFICATIONS section.
Printers are configured with an adjustable paper guide set to the customer specified width. To
change the ticket width setting, refer to section 7.1.4.
Click here to return to >
Table of Contents