Operator`s manual

APPENDIX C - DUAL MINI

This section will go over some of the unique features of the Dual Mini model printer.

• The Dual Mini has a load opto configuration. The opto closer to where you load the stock is

the ticket load opto. The opto closer where the ticket exits is the cut opto.

• The silent cutter (SC2) system is a fully integrated rotary cutter mechanism powered by a DC

motor. The SC2 requires no adjustments and is rated for approximately 750,000 cuts. Please

be aware of the following:

Wait five seconds before feeding ticket stock into the printer after power up. During this time

the SC2 will rotate once. If ticket stock is fed into the printer before five seconds, a ticket jam

could occur.

The SC2 should be blown out with air periodically to prevent debris from building up inside the

cutter area. The required cleaning interval varies greatly depending on the quality of the ticket

stock and the amount of paper dust entering the cutter area.

• To load paper stock. You will need to load path 1 first. Once path 1 has been loaded then

you can load path 2.

PATH 1

PATH 2

Silent

Cutter (SC2)