Operator`s manual

5.0 Ticket Load Procedure
Turn the printer on and wait five seconds. The red CHECK PAPER led will be illuminated (if your printer has
an optional LCD then it will display PAPER OUT). Begin loading the tickets through the entrance slot with a
smooth motion until the ticket stock comes to a stop (at this point the stock is between the thermal head and
platen). Keep pressure against the stock and the printer will automatically feed the ticket stock.
NOTE: see
Appendix C for loading of Lemur-2 and Lemur-2K printers.
Reverse Adjustable (RADJW & RADJ4)
The black timing mark on the back of
your ticket stock should past over this
side facing down towards the opto
Load your stock towards this
side and below this metal plate
Adjustable (ADJ, ADJW & ADJ2)
Load your stock towards this
side and below this metal plate
The black timing mark on the back of your
ticket stock should past over this side facing
down towards the o
p
to
Above two photos are of a Lemur and Lemur-K printer. The ticket feed area of a Lemur-2 and Lemur-2K would
look the same.
Above photo is of a Lemur-S with optional cutter. Your printer may vary.
7