Operator`s manual

4.0 Installation

The Lemur series printer was designed to be mounted either on a desktop or shelf (horizontal model) or

vertically in a counter top (see

Appendix B for installation of vertical printers).

Prior to site preparation and installation, the printer should be powered up and run in the self-test mode.

! Lay the printer flat on a counter top. On a Lemur-S model printer you will need to remove the side

cover.

! Attach the AC cord and interface cable into the proper connectors.

! Install ticket hopper (if applicable) to catch the tickets. Lemur printer without a cutter won’t have a ticket

hopper.

! Turn power on. The LCD will display PAPER OUT and the red Check Paper led will be illuminated.

You will hear the cutter motor cycle if the printer contains a cutter.

! Begin loading tickets through the entrance slot with a smooth motion until the printer automatically

positions the ticket. See section

5.0 Ticket Load Procedure.

NOTE: You want to make sure that the black timing mark is in the correct location before loading the tickets

into the paper path. See

www.bocasystems.com/tickets_specs.html for black mark layout specs.

! After the ticket is automatically positioned (the green READY led will be illuminated), press the TEST

button located on the control panel to print a test ticket. The next page shows sample self test ticket

printouts.

! Verify that the printer properly works with your system by issuing a ticket through your computer

system. You may also use out customer based program to test the printer independently of your

ticketing system (see

Appendix E)

You may now install the printer in its permanent location. Adequate room should be provided behind the

printer for the smooth feeding of ticket stock. Please do not prevent the ticket hopper (horizontal models) from

operating by touching tickets during the printing cycle.