Operator`s manual

1.0 Introduction
The Lemur series printers are direct thermal ticket printers that may be purchased with optional integrated
cutting mechanism and LCD display. This manual will provide the user with general information regarding
printer set-up, configuration and troubleshooting. Please read the important safety information section before
installation is conducted. Review the
programming guide for additional details.
2.0 Unpacking the Printer
The printer is shipped in a ruggedized container. Please save packing material for future use. Remove the
printer and accessories from the box and inspect for obvious damage. If damage is noticed, please report it
immediately to BOCA.
Email:
[e-mail] Tel: [phone] Fax: [phone]
The following items should be in the box:
a) Ticket Printer
b) Hopper (if applicable)
c) AC power cord
d) Interface cable (optional)
e) Mounting Plate (optional)
Plastic
Film To
p
Plastic
Film Bottom
NOTE: When shipping, make sure plastic film is placed on the bottom and top of printer.
Click here to return to > Table of Contents
3