Operator`s manual

PERMANENT DEFAULT GATEWAY IP ADDRESS COMMAND - <dgw10.0.1.254> (printer will reset

after receipt of command). Note: This function should only be used by an experienced user.

This command permanently changes the IP address of the default gateway and stores it in flash. The example

above would change the address to 10.0.1.254. The Gateway Address can also be changed using the

‘Factory or Web Menu’. The default address is 10.0.0.192. Note: the subnet value must be non-zero in order

for the Gateway Address to be valid.

ETHERNET PORT CONFIGURATION - <epc#> (printer will reset after receipt of command)

Normally, the printer will auto-negotiate its port configuration with the network. Some customers have asked

for the ability to manually set the speed and duplex settings of the Ethernet port. This command permanently

stores the selected port settings in flash. The values (#) can range as shown below:

0 - Auto-negotiate

1 - 100 Mbps/Full duplex

2 - 100 Mbps/Half duplex

3 - 10 Mbps/Full duplex

4 - 10 Mbps/Half duplex

Click here to return to >

Table of Contents