Operator`s manual

ManualsBrandsMikMek ManualsComputer equipmentMicro Plus

4 - reverse adjustable 2” path1

5 - reverse adjustable 2” path2

6 - reverse adjustable 2” both paths

7 - reverse adjustable 2.5” path1

8 - reverse adjustable 2.5” path2

9 - reverse adjustable 2.5” both paths

10 - reverse adjustable 2.7” path1

11 - reverse adjustable 2.7” path2

12 - reverse adjustable 2.7” both paths

13 - reverse adjustable 3.0” path1

14 - reverse adjustable 3.0” path2

15 - reverse adjustable 3.0” both paths

16 - reverse adjustable 2.125” path1

17 - reverse adjustable 2.125” path2

18 - reverse adjustable 2.125” both paths

19 – reverse adjustable 3.25” path 1 #Note: this is for RADJ4 ONLY paper guide

20 – reverse adjustable 3.25” path 2 # Note: this is for RADJ4 ONLY paper guide

21 - reverse adjustable 3.25” both paths # Note: this is for RADJ4 ONLY paper guides

CLEAR DOWNLOAD SPACE COMMAND – ESC c

This command is explained in the

FGL programming guide.

INC/DEC CUT1 COUNT COMMAND - <cca#> (printer will reset after receipt of command)

This command sets the cut count for path 1 (A). The value can usually vary from 0-30.

INC/DEC CUT2 COUNT COMMAND - <ccb#> (printer will reset after receipt of command)

This command sets the cut count for path 2 (B). The value can usually vary from 0-30.

PRINT MODE COMMANDS - <tml>/<rib>

Note: This function is set at the factory and generally should not be changed.

These commands set the printer up for Thermal <tml> or Ribbon (thermal transfer) <rib> printing.

PRINT INTENSITY COMMAND - <pi#>

Note: This function should only be used by an experienced user.

This command sets the print intensity setting for the printer. The values can range as shown below:

1 – light intensity

2 – medium light intensity

3 – normal intensity

4 – medium dark intensity

5 – short head life

TEST TICKET TYPE COMMANDS - <tst#>/<TST#>

These commands set the test ticket type that is printed off the test button. The values can range as shown

below:

0 – standard test ticket

1 – configuration 1 ( for 1 inch ticket)

2 – configuration 2 ( for 2 inch ticket)

3 – configuration 3 ( for 3 inch ticket)

4 – configuration 4 ( for 4 inch ticket)

6 – continuous test tickets

NOTE: The lowercase <tst#> commands sets the test ticket type in flash. The uppercase <TST#> command

sets the test ticket type until power is turned off. It will also print a test ticket without having to press the test

button.