Operator`s manual

APPENDIX F – DOWNLOADING SOFTWARE COMMANDS

For those Lemurs model printers without LCD display the menu setting changes may be done by utilizing the

software commands listed below. This is best done using our customer based program (see

Appendix E ).

If needed, the printer may be defaulted back to it’s originally factory settings as follows. With the printer

powered off hold down the TEST button and then power up the printer. Keep the TEST button held down for

10 seconds and release (the printer will reset at this time).

Once you have your interface or driver selected then click on the “Select Printer Operation” drop-down arrow

and choose “Enable FGL Commands (HP)”. When the FGL Command Enable box comes up, click the OK

button.

Now click on the same drop-down arrow you did in step #5 and chose “Send Text”. Once the Text Data box

comes up you type the text command in the Data input box. Then click on the OK button and the text data

will be sent to the printer.