Operator`s manual

APPENDIX E – INTERFACE TESTING A LEMUR

Boca Systems, Inc. has developed a program that allows customers to communicate from a host computer to

the printer over any interface (parallel, serial, USB, Ethernet) and print drivers too. The below programs are

found on our

website under the “Ghostwriter News “section.

For PC use without printer drivers customer program is used with Parallel, Serial & Ethernet

interfaces.

For PC use with printer drivers customer program is used with print drivers.

You may download load the program that fits your needs. To use these programs you will need to download

the executable file to your Windows based host computer and run the setup program. The following steps will

guide you through using these programs on they have been installed on your host computer.

1. Hook the BOCA printer to the host computer that you have the Customer program loaded onto. Make

sure that the printer has stock loaded and it ready to go. A printer is ready to print when it is able to

print out a self test ticket by depressing the TEST button. If you are not able to get a self test ticket,

refer to the users manual to make sure you have the printer properly setup.

2. On your Window’s desktop click on the START icon and then click on PROGRAMS to see all your

computer’s programs.

3. Find “Boca Systems” and click on one of the below to start the program.

“Customer Interfaces” – If you are connecting through a Parallel, Serial or Ethernet port

“Customer Drivers” – If you are connecting via print driver. Proceed to

step #5

4. Once the Customer Interfaces program is running, click on the “Select Printer Interface” drop-down

arrow. You will want to choose the interface connection that you have the BOCA printer hooked up to

then go to step #6.

5. Once the Customer Drivers program is running, click on the “Printer Drivers” drop-down arrow that is

found under Select A Printer. You will want to choose the driver you had downloaded for the BOCA

printer.

Your selection of drivers will vary from what is shown in above image