Operator`s manual

29
APPENDIX D – CHANGING ETHERNET PARAMETERS
CHANGING 'IP ADDRESS'
1. Please follow these steps to change the fixed IP address on your Ethernet printer. Note: if using a fixed
IP address make sure the ‘ETHERNET’ setting is set to ‘YES’ (see above).
2. Depress both the MENU and CHOICES buttons while turning on the printer. Keep both buttons
depressed until FACTORY MENU appears in the LCD window or the display starts scrolling through
different topics.
3. Using the MENU button scroll down to the IP ADDRESS? topic and press the CHOICE button.
4. The blinking cursor indicates the current IP numeric value selected. Every time you press the CHOICE
button the numeric value will change.
5. Using the TEST button will move you over to the next numeric value.
6. Continue steps 4 & 5 to program the desired IP address value.
7. At the end the display will show EXIT AND SAVE. Press the TEST button to save the IP address you
just entered.
CHANGING 'DEFAULT GATEWAY' ADDRESS
Follow same procedure as 'Changing IP address' above but in step 3 scrolls down to the DEFAULT
GATEWAY topic.
CHANGING 'SUBNET MASK' SETTING
1. Depress both the MENU and CHOICES buttons while turning on the printer. Keep both buttons
depressed until FACTORY MENU appears in the LCD window or the display starts scrolling through
different topics.
2. Using the MENU button scroll down to the Subnet Mask? topic and press the CHOICE button.
3. Each time you press the CHOICE button a different mask value will be displayed.
4. Once you have the mask value you want, press the TEST button. The display will show EXIT AND
SAVE. Press the TEST button a second time to save the address value.
Click here to return to >
Table of Contents