Operator`s manual

INC CUT1/2 COUNT? moves the cut/tear position to the left (towards the ticket entrance area). Cut counts are increments of .003” for
300dpi and .005” for 200dpi. Depressing CHOICES changes the count value. 16 is factory default. (1 is for path one; 2 is for path 2
[dual only])
DEC CUT1/2 COUNT? moves the cut/tear position to the right (towards the ticket exit area). Cut counts are decrements of .003” for
300dpi and .005” for 200dpi. Depressing CHOICES changes the count value. 16 is factory default.
PRINT MODE? Defines the automatic ticket length calculation feature.
THERMAL The printer will feed out and then retract a ticket during this measurement.
RIBBON The printer will feed out one blank ticket. This mode is used for label stock to prevent peeling.
PRINT INTENSITY? Controls the darkness of ticket print out.
Here are the following choices:
LIGHT
MED LIGHT
NORMAL (factory default)
MED DARK
SHORT HEAD LIFE
TEST TICKET? Defines they type of self-test ticket printed.
STANDARD Normal self test ticket pattern (factory default)
CONFIGURATION 1
To print configuration settings if printing on a 1” wide ticket
CONFIGURATION 2
To print configuration settings if printing on a 2” wide ticket
CONFIGURATION 3
To print configuration settings if printing on a 3” wide ticket
CONFIGURATION 4
To print configuration settings if printing on a 4” wide ticket
ETHERNET? Only used for printer with Ethernet interface connector.
NO
Ethernet not enabled.
YES
Uses the IP address that has been set in the printer by the customer.
Diagonstics
This feature should not be used.
Valid Packets
This feature should not be used.
DHCP Enabled
Automatically attempts to get an IP address from Local Server
DHCP/SUB/GATE
Automatically attempts to get an IP address/Subnet Mask/Gateway from Local Server
DHCP/NR
Automatically attempts to get an IP address from Local Server and then register the name with the
local NetBIOS name server – usually the WINS Server
DHCP/SUB/GATE/NR
Automatically attempts to get an IP address/Subnet Mask/Gateway from Local Server and then
register the name with the local NetBIOS name server – usually the WINS Server
IP ADDRESS? Enables the operator to change the printer’s Ethernet IP Address. (See Appendix D )
SUBNET MASK? Enables the operator to change the printer’s Ethernet Subnet Mask value. (See Appendix D )
DEFAULT GATEWAY? Enables the operator to change the printer’s Ethernet default Gateway value. (See Appendix D )
Programming Guide.
SPEED/DUPLEX? Enables the operator to change the printer’s Ethernet speed and duplex setting. Please consult FGL Programming
Guide. Your choices are AUTO-NEGOTIATE, 100Mbps/FULL, 100Mbps/HALF, 10Mbps/FULL and 10Mbps/HALF.
EXIT AND SAVE ! Will save any changes made to the above menu options.
If you wish to save the new value then press TEST, if not press MENU.
JUST EXIT? Will exit the menu options without saving any changes.
If you with to exit without saving the new value then press TEST, if not press MENU.
Click here to return to >
Table of Contents
26