Operator`s manual

ManualsBrandsMikMek ManualsComputer equipmentMicro Plus

APPENDIX A - CONTROL PANEL

The FGL46 printers allow the user to adjust various printer options through the optional control panel. To access the

control panel menu, press both MENU and TEST switches simultaneously for about 3 seconds. The LCD will display the

“OPERATOR MENU!” message to indicate that it has entered the control panel menu mode. Once in this mode, please

use the following steps in the manner indicated to choose the proper menu topic and to select the proper setting.

Scrolls through choices in

individual menu topics

Selects proper menu topic

(baud rate, cut count, etc.)

Enters new value. Also

saves new values

To access and use the OPERATOR MENU, follow these steps:

1. Ticket stock should be loaded into the printer. The LCD window displays FGL46G# - SB# (# - number value

depends on revision level; G represents the software series level; B# is the font)

2. Press both MENU and TEST switches simultaneously for about 3 seconds. The LCD window displays OPERATOR

MENU. (To access the factory menu, press MENU and CHOICES instead of MENU and TEST.) WARNING:

Improper use of the factory menu may disable your printer.

3. To scroll through the menu topic, use MENU stopping on the topic you wish to change.

4. Press CHOICES to scroll through choices in the selected topic. NOTE: The printer displays a blinking cursor for the

values presently stored in the printer.

5. Once you have found the new value you want, press TEST. The LCD window displays EXIT AND SAVE?. If you

wish to save the new value then press TEST again.

6. If you do not wish to save the new value then press MENU. The LCD window displays JUST EXIT?. Press

TEST to exit the OPERATOR MENU without saving new values or press MENU to enter back into the

OPERATOR MENU.

The chart below lists the present menu topics. These topics are subject to change.

OPERATOR MENU

BAUD RATE?

MINI/MICRO?

PRINT SPEED?

DIAGNOSTIC MODE?

STATUS ENABLED?

TRANSPARENT MODE?

PAPER MODE?

SPECIAL HEAD

CLEAR DOWNLOAD

INC CUT1 COUNT?

DEC CUT1 COUNT?

INC CUT2 COUNT?

DEC CUT1 COUNT?

PRINT MODE?

PRINT INTENSITY?

TEST TICKET?

ETHERNET?

IP ADDRESS?

SUBNET MASK?

DEFAULT GATEWAY?

SPEED/DUPLEX?

EXIT AND SAVE?

JUST EXIT