Operator`s manual

9.3 Logic Board

The printed circuit boards used in this product have been manufactured using surface mount

technology. These printed circuit boards cannot be effectively repaired in the field and should be

returned to the manufacturer if repair is required.

Warning: ALL SERVICE SHOULD BE DONE WITH POWER OFF AND THE AC CORD

UNPLUGGED FROM THE PRINTER.

See below pictures for main logic board access: (Click on image for larger picture)

Lemur & Lemur-K Lemur-S

(Electronics cover removed) (Rear access panel removed)

Lemur-2 & Lemur-2K

(Electronics cover removed)

9.3.1 Logic Board (Removal)

1. Gain access to the logic board. This is normally done by removing the electronics cover or rear

access panel (for Lemur-S).

2. Denote where all the cable plug into the logic board.

3. Unplug connectors connected to the main logic board.

4. Remove the four 3/16” head screws that secure the logic board onto the cabinet.

5. Lift board and remove.

Click here to return to >

Table of Contents