Operator`s manual

9.1.4 Ticket Width Adjustment
To adjust the paper path for use with a different ticket width, adjust the slider bar to the fully open position.
Insert your ticket stock into the paper guide. Adjust the slider bar down to the proper ticket width, making sure
the bar is not too tight against the ticket.
The ticket should move freely in the paper guide.
Above photo is of a RDJW paper path set for 2” wide stock
Load your stock towards this
side and below this metal plate
Slider Ba
r
Ticket Stock
The slider bar would be
located here for 3.25”
ticket width
On reverse adjustable printers (RADJW or RADJ4), the “special head” setting via the control panel must be
changed to match the new ticket width (see
Appendix A). If the printer doesn’t have the optional control panel
then the width adjustment can be made via a software command (see Appendix F).
Load your stock towards this
side and below this metal plate
Slider Ba
r
Ticket Stock
Above photo is of ADJ paper path set for 4” wide stock
No control panel adjustment is necessary on standard adjustable printers (ADJ, ADJW or ADJ2).
Click here to return to > Table of Contents
15