Operator`s manual

9.1.3 Platen (Rubber Driver Roller)

The Platen (rubber drive roller) should be cleaned once a year to prevent paper dust from building up on the

roller. (NOTE: The platen may require more frequent cleaning in dusty environments or when using inferior

ticket stock.)

1. Make sure power is off and the AC cord is disconnected from the printer

2. Unlock the cam lock lever and remove head mounting block/ plate. (Refer to section

9.1.2 Thermal Print

Head)

3. Apply a small amount of Isopropyl alcohol onto a paper towel to clean the rubber roller.

4. Clean only the part of the rubber roller where the ticket stock makes contact with.

5. Rotate the rubber roller clockwise a little and repeat step 4; continue in the same manner for

one full revolution of the rubber roller.

6. Install the head mounting block/ plate and lock the cam lock lever back in place. Printer in now

ready for normal operation.

Platen

Platen size may very from what is shown in the photo.

Click here to return to > Table of Contents