VBar Control Device Manual
Table Of Contents
- Benefits at a Glance
- Introduction
- General Safety Precautions
- Package Contents
- Transmitter Controls and Features
- Basic Transmitter Operation
- How to turn the VBar Control on and off
- The Main Screen and the Easy Dialog System
- Basic VBar Control Setup
- Transmitter Setup
- Application Setup
- How to change the Stick Mode and adjust the Stick Tension, how to change the Stick Length
- How to use VBar Control as a USB Game Controller
- Binding a VBar Control Satellite Receiver
- Battery Charging
- Tips for using your VBar Control Transmitter
- VBar Control Satellite Receiver
- Updating and Enhancing your VBar Control Transmitter
- Recycling VBar Control and the Rechargeable Battery
- Technical Data
- Getting Support and Service for your VBar Control
- Compliance Information for the U.S., Europe and Other Countries
- FCC Grants
20
FCC Grants
EQUIPMENT AUTHORIZATION is hereby issued
to the named GRANTEE, and is VALID
ONLY for the equipment identified hereon for use under the Commission's Rules and
Regulations listed below.
2ABXHVBCRX10
Mikado Model Helicopters GmbH
V
Output power listed is conducted. The antenna(s) used
for this transmitter must be installed to provide
a separation distance of at least 20 cm from all
persons and must not be co-located or operating in
conjunction with any other antenna or transmitter. Us
ers and installers must be provided with antenna
installation instructions and transmitter operating
conditions for satisfying RF exposure compliance.
EQUIPMENT AUTHORIZATION is hereby issued
to the named GRANTEE, and is VALID
ONLY for the equipment identified hereon for use under the Commission's Rules and
Regulations listed below.
2ABXHVBCTX10
Mikado Model Helicopters GmbH
V
Output power listed is conducted. The antenna(s) used
for this transmitter must be installed to provide
a separation distance of at least 20 cm from all
persons and must not be co-located or operating in
conjunction with any other antenna or transmitter. Us
ers and installers must be provided with antenna
installation instructions and transmitter operating
conditions for satisfying RF exposure compliance.