VBar Control Device Manual
Table Of Contents
- Benefits at a Glance
- Introduction
- General Safety Precautions
- Package Contents
- Transmitter Controls and Features
- Basic Transmitter Operation
- How to turn the VBar Control on and off
- The Main Screen and the Easy Dialog System
- Basic VBar Control Setup
- Transmitter Setup
- Application Setup
- How to change the Stick Mode and adjust the Stick Tension, how to change the Stick Length
- How to use VBar Control as a USB Game Controller
- Binding a VBar Control Satellite Receiver
- Battery Charging
- Tips for using your VBar Control Transmitter
- VBar Control Satellite Receiver
- Updating and Enhancing your VBar Control Transmitter
- Recycling VBar Control and the Rechargeable Battery
- Technical Data
- Getting Support and Service for your VBar Control
- Compliance Information for the U.S., Europe and Other Countries
- FCC Grants
13
allows to set the zero collective
position, even though the gimbal has no spring to center
itself. Move the stick to the precise mechanical center po-
sition according to the zero pitch line on the gimbal’s scale,
press
!.
assigns three switches needed for
basic ight operations and the directions according to your
liking. Defaults are Motor—upper left, Bank switch (ight
modes)—upper right, Buddy Box—lower right. The graph-
ics show the actual assignments.
lets you assign
functions to
switches according to your liking. Later you will assign
functions within additional apps. For this, you may
require additional hardware and/or software.
allows you to name your radio. To enter
the name, select the position and then the character, using
the EDS dial. Select
when done, select
to clear
the name and start over.
allows for basic settings of different apps.