VBar Control Device Manual
Table Of Contents
- Benefits at a Glance
- Introduction
- General Safety Precautions
- Package Contents
- Transmitter Controls and Features
- Basic Transmitter Operation
- How to turn the VBar Control on and off
- The Main Screen and the Easy Dialog System
- Basic VBar Control Setup
- Transmitter Setup
- Application Setup
- How to change the Stick Mode and adjust the Stick Tension, how to change the Stick Length
- How to use VBar Control as a USB Game Controller
- Binding a VBar Control Satellite Receiver
- Battery Charging
- Tips for using your VBar Control Transmitter
- VBar Control Satellite Receiver
- Updating and Enhancing your VBar Control Transmitter
- Recycling VBar Control and the Rechargeable Battery
- Technical Data
- Getting Support and Service for your VBar Control
- Compliance Information for the U.S., Europe and Other Countries
- FCC Grants
12
sets the low threshold for the ambi-
ent light sensor. The display will not go darker than the
value set here. To save on battery life, use the lowest con-
venient value.
is for the EDS Dial feedback as well as for
warnings and Speech Apps.
lets you select the stick mode (mind
that you have to change the hardware if you switch be-
tween throttle-left and throttle-right modes, see page 14).
In case you want to have the collective stick reversed,
choose modes 5-8 instead.
the gimbals by selecting one control
function at a time and thereby ‘show’ the VBar Control the
limits and the center position by just moving the stick. It will
learn and store the values automatically.