Full Product Manual

ManualsBrandsMigthy Mule ManualsDoors & Windows1-1/4 HP Smartphone Controlled Garage Door Opener with Built-In LED Lighting and Ultra-Quiet Belt Drive

When the red light on the remote

glows dimly, or fails to light at all

when the remote is activated, the

batteries need replacing.

4 5

1 2 3

USE COIN OR VISOR

CLIP IN SLOT TO

OPEN CASE

REPLACING THE REMOTE CONTROL BATTERY

CARFULLY REMOVE

THE BOARD

LIFT OFF TOP

OF CASE

REMOVE OLD

BATTERY AND

DISPOSE OF

PROPERLY

INSERT NEW

CR2032

BATTERY

PLUS SIDE UP

RE-ASSEMBLE

REMOTE CONTROL

KEEP BATTERIES OUT REACH OF CHILDREN. Swallowing batteries can lead to serious injury or death.

If you suspect someone has swallowed a battery, go to the hospital immediately. Do not induce vomiting

or eat or drink anything.

For more information, call the National Battery Ingestion Hot line: 202-625-3333.

The battery identi cation number for this product is CR2032, or AAA Alkaline (LR03).

WARNING

INSTALL 3 FRESH

AAA BATERIES

SLIDE BATTERY

COVER CLOSED

1 2

SLIDE BATTERY

COVER OPEN

REMOVE THE OLD

BATTERIES AND

DISPOSE OF THEM

PROPERLY

INSTALLING OR REPLACING KEYPAD BATTERIES:

REPLACING REMOTE BATTERY:

Open the remote’s case.

Remove the circuit board.

Replace old battery with new

Type CR2032 battery.

Re-assemble the remote.

Remove the two screws and

slide the battery cover off.

Remove the 3 old AAA batteries

and dispose of them properly.

Install 3 fresh AAA alkaline

batteries.

Replace the battery cover and

re-install the two screws.