Full Product Manual

26
USING THE GARAGE DOOR OPENER
Remote
Keypad
Wall
Station
Remote
Transmitter
UP/DOWN
ICON
UP/DOWN
BUTTON
Opening the Door
1 With the door in view, press the wall station’s UP/DOWN button or the
button assigned to the opener on the remote control, or enter a valid
access code and press ( ) on a wireless keypad.
2 When the opener is activated, the opener’s light will turn on and the
door will begin to open.
3 The door will open until the open limit is reached. If an obstacle is
encountered while the door is opening, the door will stop and opener’s
light  ashes four times.
4 The opener’s light will stay on for about  ve minutes after the door
stops.
Closing the Door
1 With the door in view, press the wall station’s button or the button
assigned to the opener on the remote control, or enter a valid access
code and press ( ) on a remote keypad.
2 When the opener is activated, the opener’s light will turn on and the
door will begin to close.
3 The door will close until the close limit is reached. If an obstacle is
encountered, the door will stop and reverse to open and the opener’s
light  ash four times. If the safety beam is interrupted during closing,
the door will stop and reverse to open and the opener’s light will  ash
three times.
4 The opener’s light will stay on for about  ve minutes after the door
stops.
Stopping the Door Mid-travel
1 The door can be stopped immediately at any time by pressing the wall
station’s UP/DOWN button, the remote control’s pushbutton, or press
the ( ) button on a remote keypad (if the remote keypad was used to start the door).
2 The next time the opener is activated, the door will move in the opposite direction.
MANUAL DISCONNECT
Release
Trolley
Lock
Fig. A
Release Lever
Disconnecting the Door from the Opener
1 With the door in any position (preferably closed), carefully
pull the red release handle. USE CAUTION IF THE DOOR IS
OPEN, THE DOOR MAY DROP.
2 The disconnected door can be opened or closed manually.
3 To re-connect the opener,  ip the release lever up. Raise or
lower the door manually until the opener reconnects.