Full Product Manual

Aligning the Infrared Photo Beam

1. A lit GREEN LED indicates that the

photo beams have power.

2. Adjust the beams so that the sending

unit and receiving unit are aligned.

When the RED LED lights up the

photo beams are aligned.

3. If an object blocks the infrared beam

while the door is closing, the door will

stop, then reverse and fully open (the

opener’s light will  ash three times).

4. As a safety feature, the opener will

ignore signals from all remote controls

if the door is open and the photo

beam is blocked or out of alignment.

In this case, the door can be forced

closed by pressing and holding the

wall station’s button (be sure the door

area is in clear view).

ALIGNING PHOTO BEAMS

SENDER RECEIVER

RedGreen

Green

NOTE: If the door remains idle for 5 minutes, the beam LED will turn off to save power. The beam power

turns on for 5 minutes when door moves down to the fully closed position. The beam power can be

restored for 5 minutes by pressing the light button on the wall station.

GREEN LED LIT

WHEN POWER IS ON

RED LED

STAYS LIT

WHEN BEAMS

ARE ALIGNED

RECEIVING UNIT

SENDING UNIT

The photo beam has two components,

a sender and a receiver. The sender

produces a narrow infrared beam that

travels across the bottom of the door

opening to the receiver.