Full Product Manual

CONNECTING POWER

For Grounded Outlet Connection

1. Plug in the power cord into an electrical outlet within 3 feet of the opener. If you do

not have a grounded electrical outlet with in 3 feet of your garage door opener call a

licensed electrician to install one.

2. Coil excess cord and tape or zip tie it to the top of the power head away from

moving parts.

• To prevent electrocution or  re, installation and wiring must be in compliance with local

electrical and building codes.

• To reduce the risk of electric shock, this equipment has a grounding type plug, that has a third

(grounding) pin. This plug will only ﬁt into a grounding type outlet. If the plug does not ﬁt into

the outlet, contact a quali ed electrician to install the proper outlet. Do not change the plug in

any way.

• Never use an extension cord or change the plug in any way.

• This product is only intended for use with the supplied power cord. If a suitable grounded

outlet can not be reached with the supplied power cord, contact a licensed electrical

contractor to install an outlet.

WARNING

With the garage door opener head unit’s AC power cord plugged

into an outlet, test the wall station to see it is working properly by

using it to operate the light.

• Wait a few moments until the LED on the Wall Station comes on.

• Press the light button to turn the light on and off.

If you are unable to operate the garage door operator’s light

using the Wall Station’s buttons, please go to the Wall Station

Troubleshooting section on page 33.

Turn light ON & OFF

TEST THE WALL STATION