Full Product Manual

17
Use wood screws
and drywall anchors
Route wire
through slot
in case
Use machine screws when
mounting to a single
gang box
MOUNTING TO WALL MOUNTING TO GANG BOX
Wood Screw
Machine Screw
Drywall Anchor
HARDWARE SUPPLIED
Wire Polarity is Critical:
WALLSTATION to WALLSTATION
COM to COM
WALLSTATION
COM
WALLSTATION
COM
COM
BEAM
UP
DOWN
LEARN
Wire polarity is critical with the Wi-Fi
Smart Control Wall Station.
IMPORTANT
Mount and Wire the Wall Station
Mount the wallstation to the wall or existing
electrical gang box using one of the methods
shown.
Always make sure the opener
head unit’s AC power cord is
not plugged in before wiring
or repositioning the Smart
Control Wall Station!
Connect the wall station
to the garage door opener
head unit using either the supplied or pre-existing
wires.
Use the wire that has a mark to connect the COM
terminals. Make sure that you connect the COM
terminal on the wall station to the COM terminal
on the garage door opener head unit.
Next, connect the WALL STATION terminal on the
wall station to the WALL STATION terminal on the
garage door opener head unit.
When the garage door operator installation is complete and power has been connected you will  nd
instructions on how to test the wall station on page 20 and how to use the features of the wall sta-
tion on page 27.