Full Product Manual

Photo beam wires

For non-prewired installations, route the wires from the photo beams using insulated staples supplied, up the

wall above the door hardware, over to the center of the door, then along the ceiling, and back to the opener

head. Cut the wires about 6” longer than needed to reach the opener terminals. Strip back ½” of insulation

from the ends of the wires.

WALLSTATION

COM

COM BEAM

DOWN

LEARN

BEAM

COM

Beam wires

Twist one wire from each pair together, then

twist the other wire from each pair together.

Attach either twisted pair to the opener’s

BEAM terminal. Connect the other twisted

pair to the opener’s COM terminal.

Note: If an older system is being replaced,

use wire labels to mark connection types

prior to disconnecting wires.

IMPORTANT: Be careful to route the

photo beam wiring away from any

moving parts of the door or opener.

DO NOT route wires along the rail.

DO NOT

pierce wire

with staples

1/2”