Installation manual

4-5

No Diving or Jumping. Observe all Safety Rules

GENERAL INSTRUCTIONS - BRACELESS OVAL POOLS

ASSEMBLING THE POOL FRAME

Secon

1. Finish filling the pool

a. Turn off the vacuum and carefully remove it from

the pool.

b. Fill the pool with water to 2” (5cm) below the

lowest opening. Make sure you remove any creases

from the liner in the bottom of the pool before the

water level gets too high.

c. While the pool is filling, remvoe the nails that were

holding the bottom rails in place.

d. Your pool is now installed. You must now install the

filter and pump, the skimmer and water return inlet.

Please follow the installation instructions that come

with these products.

D. FILL YOUR POOL WITH WATER

Important Note:

Before making any openings inthe liner, fill the pool with

60cm (24”) of water to stretch the liner fully. When

filling your pool, begin with a garden hose until there

is about 30cm (12”)of water in the pool. This will allow

the liner to stretch gradually. You can then use a heavier

flow to finish filling it up.

IMPORTANT SAFETY INFORMATION:

Please refer to the safety page at the beginning of this instruction manual. You must follow the rules and

information regarding placement of safety stickers on your pool.