Installation manual

No Diving or Jumping. Observe all Safety Rules
2-5
GENERAL INSTRUCTIONS - BRACELESS OVAL POOLS
ASSEMBLING THE POOL BASE
Secon
2
A. CONT. INSTALLATION OF OF BOTTOM PLATES AND BOTTOM RAILS
11
12
13
5. Measure the perimeter of your pool
a. Measure the perimeter of your pool and hammer
nails into the ground to keep the bottom rails into
place. These nails are to be removed only at the
last step-when filling up the pool. (Images 11 & 12)
6. Fill inside the pool area
a. Fill sand under the pressure plates first, make sure
it is well compacted.
b. Pour sifted sand in the centre of your pool. Ensure
that you will have enough to spread approximately
2" (2.5cm) around the inside pool area. (Image 13)
Important Note:
Use a soft measuring tape to meaure around the perimeter of
the pool. Measure from the inside of the bottom rail, the mea-
surement should equal the wall length.