Installation manual

No Diving or Jumping. Observe all Safety Rules

1-23

GENERAL INSTRUCTIONS - BRACELESS OVAL POOLS

GROUND PREPARATION

Secon

E. ASSEMBLING THE BUTTRESS STRAPS AND PRESSURE PLATES

f. Once both sides of the buttresses have been

installed perfectly, check that all is measured again

perfectly. (Image 28)

g. Add the remaining straps that join across to other

straps. Make sure the screw heads are facing

upward. Remeausre and tighten screws. Recheck

measurement again. (Image 29)

h. Measure the two intersecting axes to ensure that

the two straight sections are parallel. (Image 30)

2. Proceed to Section 2 -

Assembling the Pool Base

Important Note:

Ensure that the straps raise higher in the middle,

therefore you may need to put a little more stone dust

underneath, appx 1/2".

Note:

It may feel tedious to be always measuring, but this

only helps to ensure proper installation and avoiding

problems further on.