Installation manual

No Diving or Jumping. Observe all Safety Rules
1-17
GENERAL INSTRUCTIONS - BRACELESS OVAL POOLS
GROUND PREPARATION
Secon
1
b. Insert the three 6.35 cm (2.5”) screws with nuts in
the vertical sleeve. (Image 14)
IMPORTANT: If your pool has steel bottom plates,
Do not permanently fasten the vertical sleeve with
screws. You will need to remove the sleeve again in
order to fit the bottom plate over the T more easily,
before replacing and attaching the vertical sleeve.
c. Insert the extruded polystyrene pieces into the
opening of the horizontal sleeves with pen nuts
(located inside the pool).
(Image 15)
14
15
Important Note:
The opening of the vertical sleeve must be facing the
outside of the pool.
Inside of Pool
Outside of Pool
C. CONT. PRE-ASSEMBLY OF THE T JOINTS (BUTTRESS)