Product Manual

4 Driveway Alarm
Placing Receiver and Testing System
Receiver Placement
RESET BUTTON
LOW BATTERY LED
TRANSFORMER INPUT
VOLUME CONTROL
VISITOR LED
POWER LED
• PlacetheindoorRECEIVERinaconvenientlocationthatis
approximatelyatleast3ft.abovetheoorlevel.
• PlugtheACtransformerintoa110VACoutletandthe
charger cable into the receiver.
•ThepowerLEDonthefrontpanelwilllightup,andthere
willbeaconrmation“beep”tone.
• WhenacarpassestheSENSOR,asignalistransmitted
totheRECEIVERfromtheTRANSMITTERbymeansofa
433MHz carrier frequency. After the RECEIVER receives the
signal, the buzzer will “beep” twice, and the visit alert LED
(green)willash3timesandremainlit.TheLEDcanbe
reset by pressing the RESET button, but it is not required.
• TheLOWBATTERYLEDalertsyouwhenthetwo(2)“AA”
batteriesintheTRANSMITTERneedtobereplaced.
•TesttherangeandsystembyhavingsomeonedriveanautomobilepasttheSENSORtobesure
theRECEIVERisactivatedwhenthevehiclehaspassedtheSENSOR.Kitchenappliancesorother
electronics may interfer with reception. It may be necessary to adjust the position or relocate the
RECEIVER for optimum results. See Trouble Shooting Section on page 6.
Testing the System
• MakesuretheSENSORwireispluggedintotheTRANSMITTER.
•TemporarilyplaceTRANSMITTERonthemountingpostinground.
• WithTRANSMITTERindesiredlocationinstalltwo(2)“AA”batteries.
Installing Transmitter Batteries
IMPORTANT: “AA” batteries must be installed at the site where the TRANSMITTER will be located to ensure
proper calibration of the transmitter.
Insert
“AA” Batteries